Unable to PING PLC from PLC Ewon Flexy 201 Ewon Flexy hms.how

Natitf Config Cosy Gateway. NCP105 Universal network/PoE wall panel controller AUDAC If you do not take this step, you will not be able to reach those devices through your VPN connection If this setting is changed to NAT and TF on WAN, the LAN devices must also have their gateway IP set to the Ewon's LAN IP address

in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address. NOTE: You need set the Gateway to EWON LAN Address in all nodes (PLC/SCADA.

EWON Cosy+ EC71330 Industrial Gateway (EC71330_00MA

As we will not connect the eWON COSY to the Talk2M Servers, we will not use the "Quick Launch wizard" Troubleshooting Steps: To solve this issue: On a Cosy, connect to the device's web interface and navigate to Setup → System → Storage → Tabular Edition → Edit COM cfg and search for NatItf. in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address.

Let’s Speed up is fast, very fast ⚡ by Mutha. Troubleshooting Steps: To solve this issue: On a Cosy, connect to the device's web interface and navigate to Setup → System → Storage → Tabular Edition → Edit COM cfg and search for NatItf. in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address.

NCP105 Universal network/PoE wall panel controller AUDAC. See: How to enable NAT 1:1 on Ewon Cosy (page 4) It looks like you have configured it to go from LAN to WAN already, but you also must remember to set the default gateway in the LAN device to be the IP address of the Ewon's LAN FwrdToWAN = 1 (Forward LAN traffic to WAN) - click SAVE - Reboot EWON